Q.1
What is the use of the Adafruit FONA 3G+GPS Breakout?
  • a) To measure luminosity of something
  • b) To provide 3G Connectivity
  • c) To measure temperature
  • d) To measure Wi-Fi strength
Q.2
Which module enables GPS capabilities to the Adafruit FONA 3G+GPS Breakout?
  • a) Qualcomm 8015
  • b) Qualcomm 20111
  • c) Qualcomm 234
  • d) Qualcomm 8013
Q.3
What kind of commands does the Adafruit FONA 3G+GPS Breakout accept?
  • a) Analog Commands
  • b) BT Commands
  • c) AT Commands
  • d) TDM Commands
Q.4
What will happen if we supply a voltage ofto the Vcc of the Adafruit FONA 3G+GPS Breakout?
  • a) Damage is caused
  • b) Module will shut down
  • c) Module will not respond for the time the voltage is applied
  • d) Module will function normally
Q.5
Which port on any Arduino board should be connected to the Key Port on the Adafruit FONA 3G+GPS Breakout?
  • a) Any Digital Pin
  • b) Vcc
  • c) Gnd
  • d) Any Analog Pin
Q.6
What is the full form of the RI pin on the Adafruit FONA 3G+GPS Breakout?
  • a) Ring Indicator
  • b) Right Indicator
  • c) Right Impersonation
  • d) Rig Indicator
Q.7
How many LED indicators are present on the Adafruit FONA 3G+GPS Breakout?
  • a) 2
  • b) 1
  • c) 10
  • d) 4
Q.8
What signal should be sent to the RESET pin of the Adafruit FONA 3G+GPS Breakout in order to perform a Hard Reset of the module?
  • a) 100ms LOW Signal
  • b) Continuous HIGH Signal
  • c) 100ms HIGH Signal
  • d) Continuous LOW Signal
Q.9
Do the SPK + and – pins on the Adafruit FONA 3G+GPS Breakout have DC blocking capacitors ?
  • a) Yes
  • b) No
Q.10
What is the use of the RTSin pin on the Adafruit FONA 3G+GPS Breakout?
  • a) Right Turn Pin
  • b) Hardware Control Pin
  • c) Software Control Pin
  • d) Residue Transmitter Pin
0 h : 0 m : 1 s