Q.1
Which of the following ballast is used at points and crossings?
  • a) 40mm
  • b) 50mm
  • c) 72mm
  • d) 25mm
Q.2
Which of the following is not a cotter used on Indian Railways?
  • a) Empty end split cotter
  • b) Solid end split cotter
  • c) Centre split cotter
  • d) Side split cotter
Q.3
Which of the following is an old method for track maintenance?
  • a) Beater packing
  • b) Mechanised maintenance
  • c) Directed track maintenance
  • d) Measured shovel packing
Q.4
Which of the following method is used for the Tilting of rails?
  • a) Adzing the wooden sleepers or by providing canted bearing plates
  • b) Strain method
  • c) Providing canted bearing plates
  • d) Adzing the wooden sleepers
Q.5
Which of the following type of fittings are used by Composite sleepers?
  • a) They do not require fittings
  • b) Rubber fastenings
  • c) Twice the strength of wooden sleepers
  • d) Similar to that of wooden sleepers
Q.6
Which of the following is not a requirement of a good ballast?
  • a) Rounded
  • b) Cheap
  • c) Tough
  • d) Wear resistant
Q.7
Which of the following is another name for Tongue rail?
  • a) Toe rail
  • b) Lead rail
  • c) Switch rail
  • d) Stock rail
Q.8
Which of the following can be used in case of Bridge joints?
  • a) Metal flat or Bridge plate
  • b) Extra sleepers
  • c) Metal flat
  • d) Bridge plate
Q.9
Which is the formula for railexcess length which the inner rail gains over outer?
  • a) 4πG2
  • b) πG
  • c) 2πG
  • d) 4πG
Q.10
Which of the following is also known as another name of inner rail?
  • a) Gradient rail
  • b) Cant rail
  • c) Fixed rail
  • d) Slope rail
Q.11
Which of the following software cannot be used to design a railway track alignment?
  • a) Primavera
  • b) Ferrovia
  • c) Open Rail Designer
  • d) Trimble Quantm
0 h : 0 m : 1 s