Q.1

Junker's calorimeter is used to determine the calorific value of

  • pulverised coal
  • gaseous fuels
  • fuel oil
  • none of these
Q.2

A coal having high amount of volatile matter

  • would require smaller combustion chamber.
  • produces very little of tar and gas on carbonisation.
  • ignites easily and burns with long smoky flame.
  • all (a), (b) and (c).
Q.3

Which of the following is not used as a binder in coal briquetting ?

  • Tar
  • Molasses
  • Pitch
  • Line
Q.4

When incomplete combustion loss is high, the flue gas analysis shows large amount of

  • CO2
  • CO
  • O2
  • C
Q.5

Adiabatic flame temperature of a fuel is dependent on the initial temperature of

  • fuel
  • air
  • both (a) & (b)
  • neither (a) nor (b)
Q.6

Gray King Assay and Swelling Index of a coal is a measure of its

  • swelling characteristics.
  • abradability.
  • agglutinating properties.
  • resistance to impact breakage.
Q.7

Higher percentage of ash in coal meant for the production of metallurgical grade coke

  • decreases the hardness of coke.
  • decreases the abrasion resistance of coke.
  • causes brittleness in steel.
  • none of these.
Q.8

Fuel gases containing hydrocarbons (ie.g. coke oven gas) are not preheated before burning, mainly because

  • the hydrocarbons crack thereby choking and fouling the heat transfer surface by carbon soot.
  • it reduces its calorific value tremendously.
  • it reduces its flame temperature tremendously.
  • there are chances of explosion during preheating.
Q.9

Laboratory gas is obtained by the cracking of

  • gasoline
  • diesel
  • fuel oil
  • kerosene
Q.10

Combustion reaction of fuels is a/an __________ reaction.

  • auto catalytic
  • exothermic
  • endothermic
  • none of these
Q.11

Higher efficiency in the combustion of solid fuel can not be achieved by

  • proper fuel preparation.
  • keeping the flue gas exhaust temperature very high.
  • adopting efficient-fuel firing technique & equipment.
  • supplying correct quantity of combustion air.
Q.12

Carbon Content by weight in air dried wood may be about __________ percent.

  • 10
  • 25
  • 50
  • 80
Q.13

Size of blast furnace grade coke is __________ mm.

  • 25-80
  • 0-15
  • 15-25
  • >100
Q.14

Presence of __________ in a dry gaseous fuel does not contribute to its calorific value.

  • sulphur
  • oxygen
  • hydrogen
  • carbon
Q.15

The gas which contributes maximum to the heating value of natural gas is

  • CO
  • CO2
  • H2
  • CH4
Q.16

The temperature at which plastic layer formation takes place during carbonisation of coal varies from __________ °C.

  • 100 to 150
  • 350 to 450
  • 550 to 650
  • 700 to 850
Q.17

Which of the following gaseous fuels has the lowest calorific value ?

  • Gobar gas
  • Refinery gas
  • Converter gas
  • Blast furnace gas
Q.18

Explosion limit of blast furnace gas istogas in gas-air mixture. It means that the blast furnace gas will explode when burnt in a confined space, if its concentration in the gas-air mixture is __________ percent.

  • < 37%
  • >71%
  • in between 37 & 71%
  • none of these
Q.19

Combustion of pulverised coal as compared to that of lump coal

  • develops a non-luminous flame.
  • develops a low temperature flame.
  • can be done with less excess air.
  • provides a lower rate of heat release.
Q.20

'Wobbe index' is a characteristic of

  • solid fuels
  • gaseous fuels
  • liquid fuels
  • fat coals
Q.21

Which of the following is the most reactive (as regards the formation of CO + H2 from C + H2O) ?

  • Blast furnace coke
  • Low temperature coke
  • Anthracite coal
  • Sub-bituminous coal
Q.22

Bituminous coal

  • ignites less easily than anthracite.
  • is generally coking.
  • burns with smoky yellow flame.
  • both (b) and (c).
Q.23

Improper storage condition results in the weathering of coal and spontaneous combustion, which increases its

  • caking index.
  • yield of carbonised products.
  • friability & oxygen content.
  • calorific value.
Q.24

A coal containing very high percentage of durain is called __________ coal.

  • bright
  • splint
  • non-banded
  • boghead
Q.25

Which of the following accentuates clinker-ing trouble on furnace grate burning coal ?

  • Low reactivity of carbonised residue containing high proportions of iron & sulphur.
  • Low forced draught and fuel bed temperature.
  • Thick fire bed and preheated primary air.
  • All (a), (b) and (c).
Q.26

The internal energy of the combustion products is __________ compared to that of reactants.

  • more
  • less
  • equal
  • more or less ; (depends on the state of fuel.)
Q.27

Yield of coke oven gas in low temperature carbonisation of coal is about __________ Nm3 /ton of dry coal.

  • 60
  • 160
  • 500
  • 750
Q.28

Which of the following is not a by-product recovered in a high temperature coal carbonisation plant ?

  • Benzol
  • Pitch-cresosote mixture (PCM)
  • Napthalene
  • Ethylene
Q.29

Pensky-Marten apparatus is used for those oils, whose flash points are __________ °F.

  • <120
  • >120
  • <90
  • 90-110
Q.30

Prime coking coal is always blended with medium or non- coking coal before ear-bonisation

  • to check against its excessive swelling during heating, which may exert high pressure and damage coke oven walls.
  • because, it alone produces unreactive coke.
  • both (a) and (b).
  • neither (a) nor (b).
Q.31

Actual flame temperature is always lower than the adiabatic flame temperature, because there is

  • no possibility of obtaining complete combustion at high temperature.
  • always loss of heat from the flame.
  • both (a) and (b).
  • neither (a) nor (b).
Q.32

A coal with high ash content is undesirable, as

  • it is abrasive to the coal pulveriser (ie.g. ball mill) and the combustion chamber.
  • the ash in molten condition gets absorbed in the pores of the refractory lining of the furnace and causes its spalling due to different co-efficient of expansion/contraction of the refractory and the ash.
  • the ash retains the sulphur & phosphorus and thus affects the quality of products in metallurgical furnace apart from increasing the slag volume. Besides, it may fuse and stick to the boiler tubes thereby reducing the heat transfer.
  • all (a), (b) and (c).
Q.33

Presence of free moisture in coal during its high temperature carbonisation

  • reduces the coking time.
  • protects the volatile products from pyrolysis (cracking) in the presence of hot coke and hot oven walls.
  • increases the loss of fine coal dust from the ovens when charging.
  • none of these.
Q.34

Calorific value of coal middling generated in coal washeries during washing of coal may be around __________ Kcal/kg.

  • 1000
  • 4000
  • 6000
  • 8000
Q.35

Ratio of primary air to secondary air increases with increase in the rank of coal, because the

  • high rank coals have higher amount of volatile matter.
  • ratio of fixed carbon to volatile matter increases.
  • oxygen content progressively decreases.
  • calorific value of the coal increases.
Q.36

Which of the following constituents of coal is the most important in the production of coke?

  • Moisture
  • Ash
  • Volatiles
  • Carbon
Q.37

During combustion of gaseous fuels, deficiency of air

  • lengthens the flame.
  • tends to shorten the flame.
  • does not affect the flame length.
  • increases the flame temperature.
Q.38

Natural draught produced by a chimney depends upon the

  • density of the chimney gases.
  • height of the chimney.
  • both (a) and (b).
  • neither (a) nor (b).
Q.39

Gross & net calorific value is the same for

  • blast furnace gas
  • coke oven gas
  • L.D. converter gas
  • none of these
Q.40

Which of the following is not a product of tar distillation ?

  • Phenol & naphthalene
  • Benzol & pitch
  • Anthracene & creosote
  • None of these
Q.41

Temperature of preheated air used for the transportation of pulverised coal through pipes to the burner of a boiler furnace is restricted to a maximum limit of aboutC to avoid the

  • requirement of large volume combustion chamber.
  • risk of explosion.
  • chances of clinker formation.
  • incomplete combustion of coal.
Q.42

In high temperature carbonisation of coal compared to low temperature carbonisation

  • yield of ammonia is less.
  • aromatic content of tar is low.
  • H2 content in the coke oven gas is more.
  • calorific value of the coke oven gas is lower.
Q.43

Coke oven gas consists mainly of

  • H2, & CH4
  • CO, & CO2
  • H2, & CO
  • CH4, & CO
Q.44

Flue gas discharge velocity through chimney of a big thermal power plant may be around __________ m/sec.

  • 0.5
  • 10
  • 50
  • 500
Q.45

High temperature in gasification of coal favours

  • high production of CO2.
  • low production of CO2.
  • high production of CO.
  • both (b) and (c).
Q.46

Gross and net calorific value of a fuel will be the same

  • if its ash content is zero.
  • ifits carbon content is very low.
  • if its hydrogen/hydrogen compound content is zero.
  • under no circumstances.
Q.47

Which of the following is used for making the explosive 'TNT' ?

  • Benzol
  • Toluene
  • Pyridine
  • Cerosote
Q.48

Low temperature carbonisation

  • is mainly for producing the smokeless domestic coke.
  • is meant for the production of 'metallurgical coke'.
  • produces higher quantity of gas than high temperature carbonisation.
  • produces less quantity of tar than high temperature carbonisation.
Q.49

Softening temperature of coal ash is a measure of the __________ of coal.

  • caking tendency
  • coking tendency
  • clinkering tendency
  • size stability
Q.50

"Overfire burning" in a furnace is a phenomenon characterised by the

  • supply of excess fuel.
  • supply of excess air.
  • burning of carbon monoxide and other incombustibles in upper zone of furnace by supplying more air.
  • none of these.
0 h : 0 m : 1 s