MCQGeeks
0 : 0 : 1
CBSE
JEE
NTSE
NEET
English
UK Quiz
Quiz
Driving Test
Practice
Games
Quiz
Civil Engineering
Airport Engineering
Quiz 1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Q.1
The lift off distance is the distance along the centre of the runway between the starting point and
End of the runway
End of stop-way
Point where air craft becomes air borne
Point where air craft attains a height of 10.7 m
Q.2
The capacity of parallel runway pattern depends upon
Weather conditions and navigational aids available
Lateral spacing between two runways and weather conditions
Lateral spacing between two runways and navigational aids available
Lateral spacing between two runways, weather conditions and navigational aids available.
Q.3
The minimum width of clearway is
50 m
100 m
150 m
250 m
Q.4
If the width of the approach area near the runway end is 150 m, the width of the approach area at a distance of 3 kilometers from runway end will be
1500 m
1200 m
1000 m
800 m
Q.5
In an airport, if 4 groups of 5 gates each located well separated are considered for traffic and the future to present traffic ratio is 3, then the total requirement of future gates will be
32
36
44
68
Q.6
For determining the basic runway length, the landing case requires that aircraft should come to a stop within p % of the landing distance. The value of p is
40 %
50 %
60 %
75 %
Q.7
The maximum value of the angle of turning of the nose gear large jet aircrafts, is limited to
20°
30°
45°
60°
Q.8
The height of the pilot's eye above the runway surface is assumed
1 m
3 m
4 m
5 m
Q.9
Beaufort scale is used to determine
Strength of winds
Direction of winds
Height of air-crafts
None of these
Q.10
Assertion A: The width of a taxiway is smaller than the runway width.
Reason R: The speed of the aircraft on a taxiway is greater than that on runway.
Select your answer based on coding system given below
Both A and R is true and R is the correct explanation of A
Both A and R is true but R is not the correct explanation of A
A is true but R is false
A is false but R is true
Q.11
Pick up the correct statement from the following:
F.I.R. stands for flight information regions
Radius of control area is 160 km
Radius of control zone is 40 km
All the above
Q.12
Pick up the incorrect statement from the following:
In single engine aeroplanes, the engine is provided in the nose of the aircraft
In double engine aeroplanes, one engine on either wing is placed symmetrically
In three engine aeroplanes, two engines are placed on both wings and one engine is placed in the tail
None of these
Q.13
The coordinates of the ends of a runway are (5000, 5000) and (8000, 7000). The co-ordinates of another runway are (4600, 5100) and (7000, 5300). The co-ordinates of the A.R.P. are
(6500, 6000)
(5800, 5200)
(61500, 5600)
(8000, 7000)
Q.14
Pick up the correct statement from the following:
Air screw converts the energy given by the engine into speed
The propellers which are driven by turbine engines, are technically called turboprops
The aircrafts which obtain the thrust directly from turbine engine, are called turbo-jets
All the above
Q.15
A gradient of + 0.08% is followed by a gradient of - 0.07%. If the permissible rate of change of grade is 0.003 per 30 meters, the length of the transition curve, is
150 m
140 m
160 m
175 m
Q.16
In instrument landing system
L.O.M. and L.M.M. are installed on one side and Localizer antenna on the other side
L.O.M. and Localizer are installed on one side and L.M.M. on the other side
Localizer and L.M.M. are installed on one side and L.O.M. on the other side
None of these
Q.17
The meteorological condition which influences the size and location of an air port is
Atmosphere pressure
Air density
Reduced level
All the above
Q.18
Pick up the correct abbreviation from the following:
L.M.M. (low powered middle marker)
V.H.F. (very high frequency)
L.O.M. (low powered outer marker)
All the above
Q.19
Pick up the incorrect statement from the following:
L.O.M. is installed at 7.2 km from the threshold
L.M.M. is installed at 1.0 km from the threshold
Localizer antenna is installed at 300 m from the other end of the runway
Glide slope antenna is installed at the centre of the runway about 150 m on one side
Q.20
Pick up the correct statement from the following:
Landing speed is directly proportional to the wing loading
Wing loading remaining constant, the take off distance is directly proportional to the powder loading
Neither (A) nor (B)
Both (A) and (B)
Q.21
Pick up the correct statement from the following:
Approach zone survey is carried out to determine the elevations of the protruding obstructions above horizontal, conical and transitional surfaces
The wind data of an air port is depicted in the form of a chart known as wind rose
The landing and takeoff of the air craft is made against the wind direction
All the above
Q.22
Pick up the correct statement from the following:
Approximate geometric centre of the landing area, is called air port reference point
The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
The location of the air port on a map is the position of air port reference point
All the above
Q.23
Maximum gross takeoff weight of an aircraft is
Equal to the maximum structural landing weight
Less than the maximum structural landing weight
More than the maximum structural landing weight
Equal to the empty operating weight plus the payload
Q.24
Wing loading of an aircraft is
Load of the wings
Gross total weight of the aircraft/ load of the wings
Gross total weight of the aircraft/ wing area
Gross total weight of the aircraft/total available H.P of engines
Q.25
Which of the following factors are taken into account for estimating the runway length required for aircraft landing?
1. Normal maximum temperature
2. Airport elevation
3. Maximum landing weight
4. Effective runway gradient
Select the correct answer using the codes given below Codes:
1,2,3 and 4
1,3, and 4
2 and 3
1,2 and 4
Q.26
Airport elevation is the reduced level above M.S.L. of
Control tower
Highest point of the landing area
Lowest point of the landing area
None of these
Q.27
Pick up the incorrect statement from the following:
Channelization of pavement is caused by constant use of tri-cycle gears of aircraft
Blast pads are used over cohesion-less soils to resist erosion due to tremendous speed of the jet blast
Over-run areas of at least 300 m length on either side of the runway are provided
None of these
Q.28
The threshold markings are
4 m wide
1 m clear space between adjacent
Placed symmetrically on either side of the runway centre line
All the above
Q.29
For night landing, the thresholds are lighted
Green
Red
White
Yellow
Q.30
As per UK design criteria, if LCN of aircraft is between 1.25 to 1.5 times the LCN of pavement, then the number of movements allowed are
Zero
300
3000
Unrestricted
0 h : 0 m : 1 s
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Report Question
×
What's an issue?
Question is wrong
Answer is wrong
Other Reason
Want to elaborate a bit more? (optional)
Support mcqgeeks.com by disabling your adblocker.
×
Please disable the adBlock and continue.
Thank you.
Reload page