The portion of a brick cut across the width, is called
The entrained concrete is used in lining walls and roofs for making
The Auger borings are not common
The raft slab is projected beyond the outer walls of the structure by
The piece of a brick cut with its one corner equivalent to half the length and half the width of a full brick, is known as
Pick up the commonly adopted geophysical method in civil engineering from the following :
In English garden wall bond
Which one of the following factors is considered for the orientation of buildings :
In jack arch floor, the rise is kept
The concrete slump recommended for beams and slabs ; is
The pile which is provided with a bulb filled with concrete at its lower end, is known as
The form work from the underside of slabs, can be removed only after
The process of making the back ground rough, before plastering, is
The brick laid with its breadth parallel to the face of a wall, is known as
To ensure that supporting area of an offset footing of a boundary wall is fully compressive, the C.G. of load must act
A projecting piece usually provided to support a truss, is
Pick up the incorrect statement from the following :
While designing a stair, the product of rise and going is approximately kept equal to
The member which is placed horizontally to support common rafter of a sloping roof, is
In case of multi-storeyed buildings, the forms to be removed first are
Arches in the form of masonry arcs struck from more than four centres, are called
Black cotton soil is unsuitable for foundations because its
A wooden block hinged on post outside a door, is known
The 9 cm x 9 cm side of a brick as seen in the wall face, is generally known as
The line of intersection of the surfaces of a sloping roof forming an external angle exceeding 180°, is
Which one of the following rocks is used for monumental buildings :
For constructing a terrazo floor. Pick up the incorrect statement from the following :
Pick up the correct statement from the following:
For providing a raft foundation, the following activities are involved
The maximum permissible deflection of a timber beam supporting a roof, is
According to Rankine's formula, minimum depth of foundations, is
The type of pointing in which upper side of mortar joints is kept aboutmm inside the face of the masonry and bottom is kept flushed with face of wall, is
Open test pit is only suitable upto a depth of
The steel pile which is generally sunk in soft clay or loose sand of low bearing capacity, is
Pick up the correct statement from the following :
For plastering the exposed brick walls, the cement sand mortar should be
The stepped structure provided for lateral support of a structure, is
The projections of head or sill of a door or window frame, are
The construction joints in buildings are provided after
In the method of tube boring of soil investigation, the following is essential :
The arrangement made to support an unsafe structure temporarily, is known as
For each storey of a building, the depth of exploration should be
The local swelling of a finished plaster, is termed
For a rectangular foundation of width b, eccentricity of load should not exceed
Which one of the following piles has a cast iron shoe even after removal of the hollow cylindrical steel casing
The additional piles which are driven to increase the capacity of supporting loads on vertical piles, are known
Please disable the adBlock and continue. Thank you.