MCQGeeks
0 : 0 : 1
CBSE
JEE
NTSE
NEET
English
UK Quiz
Quiz
Driving Test
Practice
Games
Quiz
Civil Engineering
Highway Engineering
Quiz 4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Q.1
Bitumen of grade 80/100 means
its penetration value is 8 mm
its penetration value is 10 mm
its penetration value is 8 to 10 mm
its penetration value is 8 to 10 cm
Q.2
Select the correct statement.
Quantity of binder required for tack coat is less than that required for prime coat.
Prime coat treatment is given for plugging the voids in water bound macadam during bituminous road construction.
Seal coat is the final coat over certain previous bituminous pavements.
A bitumen primer is a high viscosity cutback.
Q.3
The fundamental factor in the selection of pavement type is
climatic condition
type and intensity of traffic
subgrade soil and drainage conditions
availability of funds for the construction project
Q.4
Tie bars in cement concrete pavements are at
expansion joints
contraction joints
warping joints
longitudinal joints
Q.5
If aggregate impact value is 20 to 30 percent, then it is classified as
exceptionally strong
strong
satisfactory for road surfacing
unsuitable for road surfacing
Q.6
The camber of shoulders in water bound macadam roads is
equal to the cross slope of pavement
less than the cross slope of pavement
greater than the cross slope of pavement
zero
Q.7
For a constant value of coefficient of lateral friction, the value of required super-elevation increases with
increase in both speed and radius of curve
decrease in both speed and radius of curve
increase in speed and with decrease in radius of curve
decrease in speed and with increase in radius of curve
Q.8
On a right angled road intersection with two way traffic, the total number of conflict points is
6
11
18
24
Q.9
Select the correct statement.
Psychological extra widening depends on the number of traffic lanes.
Mechanical extra widening depends on the speed of vehicle.
Psychological extra widening depends on the length of wheel base.
Psychological extra widening depends on the speed of vehicle.
Q.10
Penetration test on bitumen is used for determining its
Grade
Viscosity
Ductility
Temperature susceptibility
Q.11
The most economical lighting layout which is suitable for narrow roads is
Single side lighting
Staggered system
Central lighting system
None of the above
Q.12
Which of the following represents hardest grade of bitumen ?
30/40
60/70
80/100
100/120
Q.13
Tyre pressure influences the
total depth of pavement
quality of surface course
both the above
none of the above
Q.14
In the penetration macadam construction, the bitumen is
Sprayed after the aggregates are spread and compacted
Premixed with aggregates and then spread
Sprayed before the aggregates are spread and compacted
None of the above
Q.15
Reaction time of a driver
increases with increase in speed
decreases with increase in speed
is same for all speeds
none of the above
Q.16
For rapid curing cutbacks, the oil used is
gasoline
kerosene oil
light diesel
heavy diesel
Q.17
“Dead Slow” is a
regulatory sign
warning sign
informatory sign
none of the above
Q.18
The background colour of the informatory sign board is
red
yellow
green
white
Q.19
The recommended grade of tar for grouting purpose is
RT-1
RT-2
RT-3
RT-5
Q.20
In highway construction, rolling starts from
Sides and proceed to center
Center and proceed to sides
One side and proceed to other side
Any of the above
Q.21
The drain which is provided parallel to roadway to intercept and divert the water from hill slopes is known as
Sloping drain
Catch-water drain
Side drain
Cross drain
Q.22
Centre line markings are used
to designate traffic lanes
in roadways meant for two way traffic
to indicate that overtaking is not permitted
to designate proper lateral placement of vehicles before turning to different directions
Q.23
When the bituminous surfacing is done on already existing black top road or over existing cement concrete road, the type of treatment given is
Seal coat
Tack coat
Prime coat
Spray of emulsion
Q.24
Select the correct statement.
Nagpur road plan formula take into account the towns with very large population.
Nagpur road plan has a target road length of 32 km per 100 square km.
Second 20-year plan has provided 1600 km of expressways out of the proposed National highway.
Second 20-year plan allowed deduction of length of railway track in the area while calculating the length of roads.
Q.25
The direct interchange ramp involves
diverging to the right side and merging from left
diverging to the left side and merging from right
diverging to the right side and merging from right
diverging to the left side and merging from left
Q.26
Maximum daily traffic capacity of bituminous pavements is
500 tonnes per day
1000 tonnes per day
1500 tonnes per day
2000 tonnes per day
Q.27
The aggregates required for one kilometer length of water bound macadam road per meter width and for 10 mm thickness is
8 cubic meter
10 cubic meter
12 cubic meter
15 cubic meter
Q.28
Length of a vehicle affects
width of traffic lanes
extra width of pavement and minimum turning radius
width of shoulders and parking facilities
clearance to be provided under structures such as overbridges, under-bridges etc.
Q.29
When a number of roads are meeting at a point and only one of the roads is important, then the suitable shape of rotary is
circular
tangent
elliptical
turbine
Q.30
When the path travelled along the road surface is more than the circumferential movement of the wheels due to rotation, then it results in
slipping
skidding
turning
revolving
0 h : 0 m : 1 s
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Report Question
×
What's an issue?
Question is wrong
Answer is wrong
Other Reason
Want to elaborate a bit more? (optional)
Support mcqgeeks.com by disabling your adblocker.
×
Please disable the adBlock and continue.
Thank you.
Reload page