Q.1
Kim is placing background music under her voiceover in an advertisement. What editing technique should she use to remove part of the music at the end of the recording?
  • Fading
  • Looping
  • Trimming
  • All of above
Q.2
Reverb time (RTis the amount of time it takes for a reverberated signal to reach -60db below the direct sound level.
  • True
  • False
Q.3
Which of the following is not related to dynamic level processing?
  • flanger
  • limiter
  • gate
  • expander
Q.4
Headroom is
  • the level between the floor noise and the signal level
  • the level between the minimum and maximum dynamic range
  • the operating room between 0 db and distortion
  • the area above the distortion level in a system
Q.5
.A compressor is
  • an automatic fader
  • a gain control
  • a device that can reduce the dynamic range of program material
  • All answers are correct
Q.6
What does the "Q" of a filter refer to
  • resonance
  • bandwidth
  • resonance and bandwidth
  • none
Q.7
Which type of equalizer divides the frequency spectrum into several narrow bands?
  • graphic
  • parametric
  • graphic and parametric
  • none
Q.8
Why are gates used when miking a drum kit?
  • used to isolate drum sounds on a track
  • to allow drums to bleed together in mix
Q.9
Which control is not typical on a compressor?
  • Threshold
  • Attack
  • Release
  • Ratio
  • Frequency
Q.10
Kaitlyn is watching the controls as she is recording to make sure the volume does not go into the red area. What are the controls called?
  • Digital Master
  • VU Meter
  • Master Volume
  • All of above
Q.11
Why is it important to understand how a mixing console works when recording audio?
  • You will need to use one to record voiceovers
  • You will need to use one to record instruments
  • It is the basis for the interface in audio editing software
  • All of above
Q.12
What is the purpose of the audio fader during recording?
  • Controls how much audio goes out
  • Controls how much audio comes in
  • Controls the gain of the audio
  • All of above
Q.13
Dallas would like to add a reverb to one of the tracks in his recording. Where would Dallas find reverb?
  • Effects Rack
  • Media Browser
  • Channel Mixer
  • None of these
Q.14
A low pass filter is
  • a filter with a constant level after reaching the filters active frequency
  • a filter with a bell shaped curve around the filters' active frequency
  • a filter that cuts the high frequency component of a signal
  • a filter that cuts the low frequency component of a signal
Q.15
A high pass filter is
  • a filter with a bell shaped curve around the filters' active frequency
  • a filter with a constant level after reaching the filters active frequency
  • a filter that cuts the high frequency component of a signal
  • a filter that cuts the low frequency component of a signal
Q.16
VU meters are used to
  • indicate the average constant level of a signal
  • indicate the transient peaks of a signal
  • indicate the constant signal of a signal
  • All of above
Q.17
Peak Meters are use to
  • indicate the constant level of a signal
  • indicate the transient peaks of a signal
  • indicate the constant peaks of a signal
  • All of above
Q.18
Data communication system within a building or campus is________
  • MAN
  • LAN
  • PAN
  • WAN
Q.19
Which of the following statement is not true about the network device Switch?
  • It is a network device which is used to interconnect computers or devices on a network
  • It broadcast the signal to every node
  • It is faster and more efficient
  • It transmit data/signals to specified node only.
Q.20
What is the network device that amplifies and restores signals for long distance transmission.
  • Bridge
  • Switch
  • Router
  • Repeater
0 h : 0 m : 1 s