Q.1
Where do you load the CD Rom drivers?
Q.2
What type of commands are individual programs kept, as separate files on the hard disk (DOS diskette)?
Q.3
Which best describes a fragmented hard drive?
Q.4
Which of the following represents a correct sequence for the boot process on a DOS machine?
Q.5
When you create a subdirectory within a directory, the process is known as _____
Q.6
Match the device driver HIMEM.SYS to its operation
Q.7
What command can you add to the AUTOEXEC.BAT file so that your computer temporarily stops in the execution of the file before continuing?
Q.8
While working with MS-DOS, which command is used to sort the file in ascending order?
Q.9
What is the order in which Command.Com searches for programs to execute?
Q.10
While working with MS-DOS, which command will you use to transfer a specific file from one disk to another?
Q.11
Which command is used to send the contents of file named REPORT/TXT to the standard printing device?
Q.12
A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?
Q.13
While working with MS-DOS, which command is used to specify the size of the disk to format.
Q.14
What command is used to reset a MODEM when using the "AT Command Set"?
Q.15
The _____ command allows you to modify the default prompt to provide other information
Q.16
What DOS program can you run to see which serial ports are detected?
Q.17
HIMEM.SYS controls:
Q.18
Where would you load the mouse driver mouse.sys?
Q.19
While working with MS-DOS, which command is used to force DOS to recheck all clusters when reformatting a disk?
Q.20
The _____ switch instructs DOS to display the directory list in a wide format.
Q.21
After doing a low-level format, what would be the next step in configuring the hard drive in a system?
Q.22
Which of the following commands will take you directly to the root directory no matter what subdirectory you are currently in?
Q.23
Filename extensions help identify certain files. What filename extension identifies command files?
Q.24
Which of the following applies to Internal DOS commands?
Q.25
After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
Q.26
The MODE command of MS-DOS is used to
Q.27
Which of the following applies to external DOS commands?
Q.28
Which command is used to delete the directory that is empty?
Q.29
Which command will be used to display file and directory names only, without size, date, and time information?
Q.30
To organize files on a disk, MS-DOS separates them into areas called _____
0 h : 0 m : 1 s