Q.1
The value of a capacitor can be made larger by:
Q.2
The value of a capacitor can be made larger by:
Q.3
The primary impedance of a transformer is 60 ohm and the secondary impedance is 120 ohm. What is the impedance ratio?
Q.4
Suppose a voltage source has an ideal voltage of 12V and an internal resistance of 0.5W. For what values of load resistance will the voltage source appear stiff?
Q.5
Electron current is flowing through a conductor in a direction you might describe as straight into this page. What is the direction of the resulting magnetic field?
Q.6
The direction of electron current flow is:
Q.7
A device that converts mechanical pressure to electrical energy is called a:
Q.8
What is a negative ion?
Q.9
Which one of the following statements is true for the voltage in a parallel RC circuit?
Q.10
In a transistor operates at the middle of the load line, an increase in the base resistance will move the Q point
Q.11
Which one of the following statements most accurately applies to the frequency of a waveform?
Q.12
The Thevenin resistance is equal in value to the
Q.13
Most AC power is obtained from:
Q.14
Voltage is
Q.15
What is the turns ratio for the transformer specified in the above question?
Q.16
The merging of a free electron and a hole is called
Q.17
One henry of inductance is defined as:
Q.18
A certain power transformer has a turns ratio of 5. What voltage can you expect at the secondary winding when you apply 120 V to the primary winding?
Q.19
The total impedance of a series RLC circuit:
Q.20
What is the phase shift between total current and voltage in the circuit of a 100 ohm resistor connected in parallel with a capacitor that has a reactance of 100 ohm
Q.21
Molecule is
Q.22
Which one of the following statements is true for current flowing in a parallel circuit?
Q.23
Holes are the minority carriers in which type of semiconductor?
Q.24
A dielectric material is:
Q.25
A certain electromagnet has 1000 turns of wire. How much current must flow through the coil in order to generate an mmf of 100 ampere-turns?
Q.26
The basic unit of measurement for current is the:
Q.27
Which one of. the following phrases most accurately describes the nature of a pulsating dc voltage?
Q.28
Which one of the following statements is true for the currents in a parallel RC circuit?
Q.29
Which one of the following statements is true for current flowing in a series circuit?
Q.30
What form of energy is used for creating static electricity?
0 h : 0 m : 1 s