Alabama CDL Bus 2 - DMV Written Test Questions with Answers - MCQGeeks.com

Q.1

During a vehicle inspection, ensure that the landing gear is:

Retracted.
Fully raised.
More worn on the passenger's side than on the driver's side.
Well lit.

Q.2

If exiting a bus, a driver must:

Never make contact with the handrail.
Maintain contact with the handrail.
Move quickly.

Q.3

If exiting a bus during the basic vehicle control skills test, you must:

Keep both hands on the handrail.
Not touch the handrail.
Maintain a firm grasp on the handrail.
Rush down the stairs.

Q.4

When students board a school bus, the driver should:

Read a book.
Check all mirrors.
Only look at the students.

Q.5

When asked to complete an offset back/right parking maneuver, you should:

Pull straight forward, then back to the right.
Pull straight forward, then back to the left.
Pull forward to the right, then back in a straight line.
Pull forward to the left, then back in a straight line.

Q.6

During a basic vehicle control skills test, a look is when:

A driver checks the gauges on their instrument panel.
A driver checks their blind spots.
A driver walks to the back of their vehicle to check its position.

Q.7

When taking the basic vehicle control skills test:

Points are deducted for each pull-up.
A driver is allowed three pull-ups per maneuver.
A pull-up will earn points only if the driver gets out of the vehicle before pulling up.
Only an excessive number of pull-ups will be counted as errors.

Q.8

If you miss a student’s stop while bringing students home after school, you should:

Back up to the stop.
Follow locally established procedures.
Not worry about the student.
Stop quickly and let them exit.

Q.9

When students are being picked up by a school bus:

The students should wait at a designated bus stop.
The driver should stop to pick up students who are walking to a designated bus stop.
The parents may choose where the bus stops are located.

Q.10

If a bus is equipped with outside convex mirrors, they will be located:

Below the outside flat mirrors.
Above the outside flat mirrors.
Next to the door.
On top of the bus.

Q.11

When alley docking, you should first:

Position your vehicle directly in front of the alley.
Back up directly in front of the alley.
Stop parallel to the outer boundary of the alley.

Q.12

When you are approaching a bus stop, the students on your bus should:

Remain seated.
Stand up and collect their belongings.
Walk to the front of the bus and prepare to exit.
Ask the driver questions.

Q.13

The overhead rearview mirror is located:

On the outside left of the bus.
On the outside right of the bus.
Above the windshield inside the bus.

Q.14

When dropping off students at a school, a driver should:

Secure the bus by turning off the engine.
Leave the key in the ignition, if leaving the driver’s compartment.
Read a book while students unload.

Q.15

If equipped, a header board should:

Be damaged.
Be loose.
Be strong enough to contain cargo.
Light up when the engine is started.

Q.16

When conducting a vehicle inspection, you will need to identify all of the following, except:

The power steering belt.
The water pump belt.
The alternator belt.
The water compressor belt.

Q.17

As a general rule, where should students be kept during an emergency?

On the bus
On the side of the road near the bus
In a field away from the bus

Q.18

A passive railroad crossing:

Has a control device.
Does not have any control devices.
Should be avoided.

Q.19

The overhead rearview mirror is located:

On the right side of a bus.
On the steering wheel of a bus.
Above the windshield inside a bus.

Q.20

During the basic control skills test, you will receive points if you:

Pull up once.
Check your positioning.
Cross over exercise boundaries.

0 h : 0 m : 1 s