Indiana CDL Bus 2 - DMV Written Test Questions with Answers - MCQGeeks.com

Q.1

When asked to complete an offset back/right parking maneuver, you should:

Pull straight forward, then back to the right.
Pull straight forward, then back to the left.
Pull forward to the right, then back in a straight line.
Pull forward to the left, then back in a straight line.

Q.2

During a basic vehicle control skills test, what is considered a look?

Walking to the back of a vehicle to check its position
Using side mirrors to check a vehicle's position
Looking out of the driver's side window to check a vehicle's position
A driver glancing over their shoulder to check blind spots

Q.3

When entering traffic on an expressway during the skills test, you should:

Check for traffic.
Not use signals.
Abruptly enter a lane of traffic.
Cut off other drivers if needed.

Q.4

When driving through a curve during the skills test, you should:

Veer from your lane if needed to complete the curve.
Reduce your speed after entering the curve.
Refrain from looking for other vehicles while turning.
Reduce your speed before entering the curve.

Q.5

An active railroad crossing:

Has a traffic control device installed at the crossing.
Does not have any traffic control devices installed at the crossing.
Is characterized by having at least 10 vehicles cross the tracks every hour.
Should be avoided.

Q.6

When performing the stop/start maneuver as a part of the skills test, you should:

Cut off other vehicles if needed to get onto the shoulder.
Not use any turn signals.
Slam on the brakes to stop as quickly as possible.
Decelerate smoothly.

Q.7

The overhead inside rearview mirror:

Allows the driver to see what is happening inside of the bus.
Allows the driver to see what is happening outside of the bus.
Monitors traffic.
Opens and closes the door.

Q.8

When alley docking, your vehicle should be parked:

With the front bumper on top of the front boundary line.
With the rear wheels over the rear boundary line.
Straight within the boundaries of the parking space.
At an angle within the boundaries of the parking space.

Q.9

Properly adjusted outside convex mirrors should allow the driver to see:

The entire side of the bus up to the mirror mounts.
The front of the bus.
The rear door of the bus.
The top of the bus.

Q.10

If a bus is equipped with outside convex mirrors, they will be located:

Below the outside flat mirrors.
Above the outside flat mirrors.
Next to the door.
On top of the bus.

Q.11

During the basic control skills test, you can acquire points by:

Crossing over an exercise boundary.
Pulling up one time.
Exiting the vehicle one time to check your positioning.
Setting the parking brake.

Q.12

In a school bus, where is the overhead inside rearview mirror located?

Above the windshield on the driver’s side of the bus
Above the door on the passenger side of the bus
Above the emergency door in the rear
Under the driver's seat

Q.13

After students unload at a school, the driver:

May assume students have taken all of their belongings with them.
Should assume the students have immediately cleared the doorway.
Should walk through the bus and check for any sleeping or hiding students.
May turn off the dispatch radio.

Q.14

When checking tire condition during the vehicle inspection, you should:

Ensure that the insides of the tires are more worn than the outsides of the tires.
Ensure that the outsides of the tires are more worn than the insides of the tires.
Ensure that the middles of the tires are more worn than the outsides of the tires.
Ensure that the tires have even wear.

Q.15

As a general rule, student safety is best maintained by:

Keeping the students on the bus.
Letting some students evacuate the bus, while others stay on.
Letting students evacuate the bus.
Creating panic.

Q.16

When driving on the expressway during the skills test, you should:

Switch lanes frequently.
Use your mirrors to check traffic as needed.
Drive on the left side of the lane.
Drive above the posted speed limit.

Q.17

When taking the on-road driving skills test, you will be evaluated on your gear usage. You should not:

Avoid grinding or clashing gears.
Select a gear that does not rev the engine.
Forget to shift through an intersection.
Shift while taking a turn.

Q.18

During the pre-trip inspection test, you will be:

Expected to explain your knowledge of the pre-trip process.
Watching someone else check your vehicle.
Watching a film on how to inspect a vehicle.
Changing all the tires on your vehicle.

Q.19

A blind spot extends at least ____ behind a school bus.

10 feet
50 feet
100 feet
1,000 feet

Q.20

When students unload, they should:

Remain seated until they are told to exit.
Stand up and head toward the door while the bus is still moving.
Exit the bus and stand next to the bus until it leaves.
Jump down from the top step.

0 h : 0 m : 1 s