Q.1
What can happen if the exhaust system is not working properly?
Q.2
What is a tire load?
Q.3
When exiting your vehicle, you:
Q.4
If convicted of a traffic violation, you must inform your employer:
Q.5
When a vehicle is started, warning lights and buzzers:
Q.6
Applying the brake pedal causes air pressure to activate an electric switch and:
Q.7
When driving with covered cargo, a cover that flaps:
Q.8
With the exception of the straight line backing exercise, a driver may exit their vehicle and check its position during testing exercises up to:
Q.9
After traveling under an overpass during the driving skills test, you may be asked to recall:
Q.10
The suspension system:
Q.11
The driver of a commercial motor vehicle:
Q.12
To determine if a vehicle can handle a load, you should:
Q.13
When performing a pre-trip inspection, you should make sure that:
Q.14
If driving so slowly that you could impede other drivers, you should:
Q.15
When transporting cargo, drivers must check the securement of the cargo every:
Q.16
The most common type of foundation brake used is the:
Q.17
After a tire has been changed, the driver should stop after a short distance to:
Q.18
A driver may have:
Q.19
How should you test the low pressure warning signal?
Q.20
What can happen if a parking brake is used in very wet weather when temperatures are below freezing?
Q.21
If you remain in neutral for too long while switching gears:
Q.22
What must be done if a load is over-length?
Q.23
What is axle weight?
Q.24
If you don't know if there is enough space for your vehicle to pass under a bridge, you should:
Q.25
Overloading a vehicle with cargo:
Q.26
If your coolant level is found to be low, you should:
Q.27
On trucks and buses, where are ABS malfunction lamps located?
Q.28
A vehicle inspection is required:
Q.29
After a tire has been changed, the driver should stop after a short distance to:
Q.30
Once stopped as part of the stop/start maneuver, you should:
Q.31
The minimum tread depth of all major grooves on tires that are not on the front of a CMV should be a minimum of:
Q.32
Braking mechanisms are located inside:
Q.33
One way to prevent drowsiness while driving is to:
Q.34
Where must placards be placed?
Q.35
When conducting a vehicle inspection, you will need to identify all of the following, except:
Q.36
When driving, your mirrors should:
Q.37
States verify that a CDL or CLP driver has only one such license by:
Q.38
Which of the following is not a possible cause of a fire?
Q.39
What is Gross Vehicle Weight (GVW)?
Q.40
On any upgrade, gravity will:
Q.41
Which of the following is not a part of an air brake system?
Q.42
One way to prevent hydroplaning on wet road surfaces is to:
Q.43
When taking the on-road driving skills test, you will be evaluated on your gear usage. You should not:
Q.44
If trying to correct a drive-wheel braking skid, the driver should:
Q.45
If driving a school bus, your four-way flashers should:
Q.46
Which of the following is a good rule to follow when making a turn?
Q.47
When starting from a complete stop, a vehicle should:
Q.48
Cargo with a high center of gravity:
Q.49
What is the minimum number of tie-downs required to secure a 10-foot piece of cargo?
Q.50
What happens when a vehicle hydroplanes?
0 h : 0 m : 1 s