Q.1
A one-way check valve:
Q.2
During a walk-around inspection, ensure there are no cracks on the brake drums that are more than ____ of the width of the friction area.
Q.3
If the low pressure warning light comes on while you are driving:
Q.4
The air entering air storage tanks may contain:
Q.5
Before driving a vehicle with a dual air brake system, you must wait for the air compressor to build a minimum of ____ in both the primary and secondary systems.
Q.6
If one air system in a dual air brake system is very low on pressure:
Q.7
At what psi is the safety valve set to open?
Q.8
If the air pressure warning light comes on, you should:
Q.9
To make a stop in a vehicle using air brakes, the driver should:
Q.10
A vehicle equipped with an Anti-Lock Braking System (ABS) uses a ____ light to warn that the system is not working properly.
Q.11
A tank endorsement is:
Q.12
Both systems in a dual air brake systems share:
Q.13
In a dual air brake system, a leak in one system:
Q.14
The ____ tells a driver how much pressure is in the air tanks.
Q.15
Where is the safety relief valve usually located?
Q.16
What should happen if the air pressure in the air brake system tanks falls below 60 psi?
Q.17
An Anti-Lock Braking System (ABS):
Q.18
If a vehicle has air brakes, the air compressor drive belt should be checked before each drive. In what condition should the belt be?
Q.19
Air tank drains:
Q.20
The air storage tanks:
Q.21
The air compressor governor controls:
Q.22
Brake fade is a result of:
Q.23
Most heavy-duty vehicles use:
Q.24
To inspect slack adjusters on S-cam brakes, you need to:
Q.25
The brake pedal is part of which braking system?
0 h : 0 m : 1 s