Oklahoma CDL Bus 1 - DMV Written Test Questions with Answers - MCQGeeks.com

Q.1

When approaching a school bus stop, the bus driver should:

Not use their mirrors.
Approach the stop with caution.
Stop on the sidewalk.

Q.2

When performing a pre-trip inspection and looking into the fifth wheel gap, you should:

Make sure the locking jaws are open.
Make sure the locking jaws are fully closed around the kingpin.
Make sure the locking jaws are loose.

Q.3

When boarding a school bus, students should:

Be in a single-file line.
Be in pairs.
Not use the handrail.

Q.4

When dropping off students at a school, a driver should:

Secure the bus by turning off the engine.
Leave the key in the ignition, if leaving the driver’s compartment.
Read a book while students unload.

Q.5

Adjust a bus's mirrors:

Before operating the bus.
While operating the bus.
At the first stoplight after starting your shift.

Q.6

If your bus is equipped with a roof-mounted strobe light, it should be used:

In times of limited visibility.
All the time.
Only at night.

Q.7

When students are being picked up by a school bus:

The students should wait at a designated bus stop.
The driver should pick up students whether or not they are at the designated bus stop.
The parents should choose where the bus stop will be located.

Q.8

Loading and unloading a bus:

Can be hazardous for passengers.
Should be supervised by someone other than the driver.
Should be done when refueling.

Q.9

When students board a bus, they should:

Sit in the back row first.
Sit in the back row only after all other seats are filled.
Be seated as far from the driver as possible.

Q.10

When loading or unloading passengers, a school bus should be placed in ____ if there is no park shift point available.

Reverse
First gear
Neutral

Q.11

If a bus must be evacuated, it is safest for students to:

Stand no more than 50 feet away from the bus.
Stand downwind of the bus in the event of a fire.
Be led far away from any railroad tracks.

Q.12

When students are boarding a school bus, the driver should do all of the following, except:

Check all mirrors for students rushing toward the bus.
Count the number of students at the bus stop and ensure all have boarded.
Allow student to board in pairs.

Q.13

When a school bus is approaching a bus stop, the driver should:

Not use the mirrors.
Approach with caution.
Drive quickly and stop abruptly.

Q.14

An encroachment is when:

A driver does not appear for their scheduled basic skills test.
A vehicle touches an exercise boundary line during the basic skills test.
A driver fails one section of the basic skills test.

Q.15

During the vehicle inspection test, you must be able to adequately check all of the following, except:

The power steering belt.
The water compressor belt.
The alternator belt.

Q.16

Before a trip, you should make sure that:

The brake pedal sticks.
The gas pedal is loose.
The grooved pedal surface has not been smoothed out.

Q.17

If you come to railroad tracks while driving a school bus, you should generally:

Check the tracks, but continue driving without stopping.
Stop 15 to 50 feet before the nearest rail.
Stop 75 feet before the nearest rail.

Q.18

The inside rearview mirror is used to:

See passengers.
See potential hazards on the road.
See vehicles trying to switch lanes.

Q.19

As a general rule, where should students be kept during an emergency?

On the bus
On the side of the road near the bus
In a field away from the bus

Q.20

When making a stop to pick up students, a driver should ensure all surrounding traffic has stopped before:

Opening the door and signaling for the students to approach.
Turning on the alternating red lights.
Pulling over to the side of the road.

0 h : 0 m : 1 s