Q.1
Out of the following which is an insulating material?
Q.2
It becomes more difficult to remove
Q.3
An open resistor, when checked with an ohmmeter reads
Q.4
Sparking occurs when a load is switched off because the circuit has high
Q.5
Electric current passing through the circuit produces
Q.6
In the case of direct current
Q.7
In a lamp load when more than one lamp are switched on the total resistance of the load
Q.8
One Newton meter is same as
Q.9
The filament of an electric bulb is made of
Q.10
A 3 Q resistor having 2 A current will dissipate the power of
Q.11
Electric pressure is also called
Q.12
Whether circuit may be AC. or D.C. one, following is most effective in reducing the magnitude of the current.
Q.13
Varistors are
Q.14
The hot resistance of the bulb's filament is higher than its cold resistance because the temperature coefficient of the filament is
Q.15
Voltage dependent resistors are used
Q.16
Voltage dependent resistors are usually made from
Q.17
The resistance of a parallel circuit consisting of two branches is 12 ohms. If the resistance of one branch is 18 ohms, what is the resistance of the other?
Q.18
Temperature coefficient of resistance is expressed in terms of
Q.19
With rise in temperature the resistance of pure metals
Q.20
Which of the following statement is correct?
Q.21
The resistance of a copper wire 200 m long is 21 ω. If its thickness (diameter) is 0.44 mm, its specific resistance is around
Q.22
The weight of an aluminium conductor as compared to a copper conductor of identical cross-section, for the same electrical resistance, is
Q.23
Two lamps 100 W and 40 W are connected in series across 230 V (alternating). Which of the following statement is correct?
Q.24
With three resistances connected in parallel, if each dissipates 20 W the total power supplied by the voltage source equals
Q.25
The insulation on a current carrying conductor is provided
Q.26
Three identical resistors are first connected in parallel and then in series. The resultant resistance of the first combination to the second will be
Q.27
When current flows through heater coil it glows but supply wiring does not glow because
Q.28
Which method can be used for absolute measurement of resistances?
Q.29
A field of force can exist only between
Q.30
In a circuit a 33 Q resistor carries a current of 2 A. The voltage across the resistor is
0 h : 0 m : 1 s