Q.1
Solar thermal power generation can be achieved by
Q.2
The capacity of large turbo-generators varies from
Q.3
The isentropic expansion of steam through nozzle for the steam initially superheated at inlet is approximated by equation
Q.4
In a surface condenser if air is removed, there is
Q.5
Economiser is used to heat
Q.6
Steam turbines are governed by the following methods
Q.7
The cooling section in the surface condenser
Q.8
The thermal efficiency of the engine with condenser as compared to without condenser, for a given pressure and temperature of steam, is
Q.9
In steam turbines the reheat factor
Q.10
The maximum percentage gain in Regenerative feed heating cycle thermal efficiency
Q.11
Rateau steam turbine is
Q.12
Caking coals are those which
Q.13
TravelUng grate stoker can burn coals at the rates of
Q.14
In case of impulse steam turbine
Q.15
Load center in a power station is
Q.16
The efficiency of chimney is approximately
Q.17
Where unpulverised coal has to be used and boiler capacity is large, the stoker which is used is
Q.18
The pressure on the two sides of the impulse wheel of a steam turbine
Q.19
The ratio of exit pressure to inlet pressure of maximum mass flow rate per area of steam through a nozzle when steam is initially superheated is
Q.20
The draught in locomotive boilers is produced by
0 h : 0 m : 1 s