Which of the following is equivalent to x?

Consider the following statements:

1. Internal sorting is used if the number of items to be sorted is very large.
2. External sorting is used if the number of items to be sorted is vary large.
3. External sorting needs auxiliary storage.
4. Internal sorting needs auxiliary storage.

Consider the following:

1. Si
2. Ge
3. GaAs
4. InP

The characteristic polynomial of a system is q(s) = 2s⁵ + s⁴ + 4s³ + 2s² +The system is :

A DC voltage source is connected across a series R - L - C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

A rectangular wave guide is designed to propagate at the dominant mode TE₁₀ at a frequency of 5 GHz. The cut-off frequency is 0.8 of signal frequency. The ratio of the guide width to height isThe dimensions of the guide are

The fuse material used in electrical lines must have which one of the following properties?

Which of the following statements is not correct?

If D, G and η denote the directly, power gain and efficiency of an antenna, then which of the following relation holds :

If the potential functions V₁ and V₂ satisfy Laplace's equation within a closed region and assume the same values on its surface, then which of the following is correct?

Which one of the following statements is correct for MOSFETS?

Which of the following bridges is also used in an oscillator?

A lossless transmission line with air dielectric is 6 m long. what is the phase constant?

A memoryless source emits n symbols each with a probability p. The entropy of the source as a function of n

If there is phase error in the carrier signal for the detection of SSB signals, then

How many and which types of machine cycles are needed to execute PUSH PSW bymicroprocessor?

In a series LCR circuit the maximum inductor voltage is twice the maximum capacitor voltage however current lags byand drop across the inductance is v_L =sin 377t V. Assuming the resistance beingΩ, Find the values of the capacitance and inductance.

Unit doublet is the Laplace inverse of __________ .

The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of

Which device can detect the presence of both forward and backward waves in a waveguide?

The correct sequence of subsystems in an FM receiver is

Which of the following statements about the matched filter in a communication receiver are correct?

1. Its impulse response depends on the signed shape
2. It maximizes the SNR at the detection shape.
3. It produces ISI.
4. It may produce phase error if synchronization is improper.

A DC voltage source is connected across a series R - L - C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

Which of the following describe the correct properties of an emitter follower circuit?

1. It is a voltage series feedback circuit.
2. It is a current series feedback circuit.
3. Its voltage gain in less than unity.
4. Its output impedance is very low.

In the Taylor series expansion of exp(x) + sin(x) about the point x = p, the coefficient of (x - p)² is

With respect to transmission parameters, which one of the following is correct?

Why npn-transistors are preferred over pnp-transistors?

Which of the following is NOT associated with a p-n junction?

F = ∑(=

In the following circuit , the comparator output in log: "I" if V₁ > V₂ and is logic "otherwise. The D/A conversion is done as per the relations V_DAC = 2^n-2 Volts, where b₃ (MSB), b₂, b₁ and b₀ (LSB) are the counter outputs. The counter starts from the clear state

The stable reading of the LED display is

Choose the correct statement

If (x x(10)_x = (100)_x; (100)_x x (100)_x = (10000)_x then x can take value

Consider two random processes x(t) and y(t) have zero mean, and they are individually stationary. The random process is z(t) = x(t) + y(t). Now when stationary processes are uncorrelated then power spectral density of z(t) is given by

Inmicroprocessor based system running at 3 MHz clock frequency what should be the minimum pulse width of the INTR signal, so that it is recognized successfully?

A n-type silicon sample contains a donor concentration of N_d = 2 x 10¹⁶ cm^-3. The minority carrier hole lifetime is t_p0 = 5 μs. The thermal equilibrium generation rate of hole is:

Consider aPLL with R_T =kΩ and C_T = 0.μF. What is the output frequency of the VCO?

For parallel plane waveguides, which is the mode with lowest cut-off frequency?

Which of the following conditions must be satisfied for a transistor to remain under saturation?

1. Its collector to base junction should be under forward bias.
2. Its collector to base junction should be under reverse bias.
3. Its emitter to base junction should be under reverse bias.
4. Its emitter to base junction should be under forward bias.

Costa's receiver is used for

Epitaxial growth is used in ICs

A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with e_r =The reflection coefficient for normal incidence is

The transfer characteristic for the precision rectifier circuit shown below is (assume ideal OP-AMP and practical diodes)

Consider two random processes x(t) and y(t) have zero mean, and they are individually stationary. The random process is z(t) = x(t) + y(t). Now when stationary processes are uncorrelated then power spectral density of z(t) is given by

If the intrinsic resistivity at 300°K is 0.ohm-m and the electron and hole mobilities at 300°K are 0.and 0.m²/volt-sec, then the intrinsic carrier concentration of Germanium is __________ .

In the design of a single mode step index optical fiber close to upper cut-off, the single mode operations is NOT preserved if

Which of the following bridges is also used in an oscillator?

The property not valid for basic singularity function is

The maximum concentration of the element which can be dissolved in solid silicon at a given temperature is termed as

The correct sequence of subsystems in an FM receiver is

When a particular mode is existed in a waveguide, there appears an extra electric component, in the direction of propagation. In what mode is the wave propagating?