A reverse biased diode will act as an open switch.
The small amount of ac signal present on the output of a filtering network for a dc power supply is known as ________.
In a diode schematic, the anode is represented by a(n):
When matching polarity connections have been made and the potential difference (PD) is above 0.7 V, the diode is considered to be:
If the diode in a series circuit is reverse biased, the resistor will drop all the applied voltage.
The PIV rating of a diode in a full-wave bridge rectifier is more than that required for a full-wave center-tapped configuration.
An IC regulator receives an overload; it will:
With full-wave rectification, current through the load resistor must be:
In a power supply diagram, which block indicates a smooth dc output?
If a 169.7 V half-wave peak has an average voltage of 54 V, what is the average of two full-wave peaks?
The troubleshooting process for a typical dc power supply contains four steps.
An electron can move to another atom's orbit only while in the _______.
A characteristic curve is the result of a current versus voltage plot of diode activity, which begins at the:
The number of electrons in a stable atom is the same as the number of protons in its nucleus.
Rectifier output polarity depends upon:
The characteristic curve for the complex model of a silicon diode shows that
What is the percent of regulation if Vnl = 20 V and Vfl = 19.8 V?
Atoms in a silicon crystal are held together by ___ bonds.
With a half-wave rectified voltage across the load resistor, load current flows for what part of a cycle?
Electrons in the outermost orbit or shell of an atom are called
Please disable the adBlock and continue. Thank you.