The Q of a crystal _________.
All of the following are basic op-amp input modes of operation EXCEPT
In an open-loop op-amp circuit, whenever the inverting input (–) is negative relative to the noninverting input (+), the output will:
How many leads does the TO-5 metal can package of an operational amplifier have?
The voltage follower has a:
A circuit whose output is proportional to the difference between the input signals is considered to be which type of amplifier?
With a differential gain of 50,000 and a common-mode gain of 2, what is the common-mode rejection ratio?
If a noninverting amplifier has an RIN of 1000 ohms and an RFB of 2.5 kilohms, what is the RIN voltage when 1.42 mV is applied to the correct input?
The ratio between differential gain and common-mode gain is called:
With negative feedback, the returning signal
If the input to a comparator is a sine wave, the output is a:
What three subcircuits does a phase locked loop (PLL) consist of?
Input impedance [Zin(I)] of an inverting amplifier is approximately equal to:
If the gain of a closed-loop inverting amplifier is 3.9, with an input resistor value of 1.6 kilohms, what value of feedback resistor is necessary?
The major difference between ground and virtual ground is that virtual ground is only a:
The closed-loop voltage gain of an inverting amplifier equals:
What is the output waveform?
What is the cutoff frequency of this low-pass filter?
If ground is applied to the (+) terminal of an inverting op-amp, the (–) terminal will:
An astable multivibrator is also known as a:
If an op-amp has one input grounded and the other input has a signal feed to it, then it is operating as what?
A differential amplifier has a common-mode gain of 0.2 and a common-mode rejection ratio ofWhat would the output voltage be if the single-ended input voltage was 7 mV rms?
The common-mode voltage gain is
With negative feedback, the returning signal:
If the feedback/input resistor ratio of a feedback amplifier is 4.6 with 1.7 V applied to the noninverting input, what is the output voltage value?
An ideal operational amplifier has
The magnitude of closed-loop voltage gain (Acl) of an inverting amplifier equals:
Please disable the adBlock and continue. Thank you.