Q.1
In an assembly of hole and shaft, smallest hole was having diameter of 49.mm and largest shaft was having diameter of 49.mm. Minimum clearance in mm will be
  • a) .08
  • b) .03
  • c) .001
  • d) .04
Q.2
In an assembly of hole and shaft, smallest shaft was having diameter of 49.mm and largest hole was having diameter of 50.mm. Maximum clearance in mm will be
  • b) 0.26
  • c) 0.32
  • d) 0.12
  • a) 0.23
Q.3
In an assembly of hole and shaft, largest shaft was having diameter of 50.mm and smallest hole was having diameter of 49.mm. Maximum interference in mm will be
  • a) 0.2
  • b) 0.3
  • c) 0.3
  • d) 0.1
Q.4
In an assembly of hole and shaft, minimum shaft diameter is 49.mm and maximum shaft diameter is 48.mm. It is an example of
  • a) Clearance fit
  • b) Interference fit
  • c) Transition fit
  • d) None of the mentioned
Q.5
In an assembly of hole and shaft, smallest shaft was having diameter of 50.mm and largest hole was having diameter of 50.mm. Minimum interference in mm will be
  • a) 0.2
  • b) 0.3
  • c) 0.3
  • d) 0.1
Q.6
Maximum material limit of shaft is
  • a) Maximum diameter of hole
  • b) Maximum diameter of shaft
  • c) Smallest diameter of hole
  • d) Minimum diameter of shaft
Q.7
Maximum material limit of hole is
  • a) Maximum diameter of hole
  • b) Maximum diameter of shaft
  • c) Smallest diameter of hole
  • d) Minimum diameter of shaft
Q.8
Minimum material limit of shaft is
  • a) Maximum diameter of hole
  • b) Maximum diameter of shaft
  • c) Smallest diameter of hole
  • d) Minimum diameter of shaft
Q.9
Minimum material limit of hole is
  • a) Maximum diameter of hole
  • b) Maximum diameter of shaft
  • c) Smallest diameter of hole
  • d) Minimum diameter of shaft
Q.10
Allowance of hole and shaft assembly is equal to
  • a) Sum of maximum metal limit
  • b) Product of Maximum limit
  • c) Difference of maximum metal limit
  • d) None of the mentioned
0 h : 0 m : 1 s