Q.1
The included angle for V-belt is
  • 30 degree to 40 degree
  • 40 degree to 50 degree
  • 20 degree to 30 degree
  • 50 degree to 60 degree
Q.2
The cross section of V- belt is .............
  • Rectangular
  • Trapezoidal
  • Triangle
  • Circular
Q.3
Which of the following drive has no Slip
  • Belt Drive
  • Rope Drive
  • Chain Drive
  • None of the Above
Q.4
Which type of belt is used with sprockets?
  • F.H.P V-belt
  • Timing belt
  • Flat belts used on conveyors
  • Multiple V-belts
  • None
Q.5
The intermediate mechanisms which is used to transmit power from one place to another place
  • Pulley
  • Machine
  • Drive
  • Lever
Q.6
V belts are suitable for
  • Short drives
  • Long drives
Q.7
V belts are molded into
  • Circular shape
  • Triangular shape
  • Trapezoidal shape
  • None of the above
Q.8
Which type of belt drives is used in compressors
  • Flat belt drives
  • V belt drives
Q.9
The included angle for v belt drive ranges from
  • 10 to 20 degree
  • 20 to 30 degree
  • 30 to 40 degree
  • All of above
Q.10
If the driving sheave of a belt has an outside diameter of 6 inches and the driven sheave has an outside diameter of 3 inches, the driven sheave rotates
  • two times faster than the driving sheave
  • half as fast as the driving sheave
  • slower than the driving sheave
  • at the same speed as the driving sheave
  • impossible to tell from the given data
Q.11
Which parameters are represented by the two scales on a belt tension tester?
  • Deflection distance and belt span
  • Deflection force and belt type
  • Deflection force and belt width
  • Deflection distance and small sheave diameter
  • Deflection force and belt span
Q.12
Gear drive don't require precise alignment of shaft.
  • True
  • False
Q.13
Which of the following is not true about gear drives.
  • Positive drive
  • Constant velocity ratio
  • Transmit large power
  • Bulky construction
Q.14
The teeth of the helical gears are cut parallel to the shaft axis
  • True
  • Flase
Q.15
Due to slip of the belt, the velocity ratio of the belt drive
  • Decreases
  • Increases
  • Does not change
  • None of the above
Q.16
Spur Gears are used for connecting two..................
  • Parallel and Coplanar Shafts
  • Non Parallel and Coplanar Shafts
  • Parallel and non coplanar Shafts
  • Intersecting and Coplanar Shafts
Q.17
The stress Produced on the belt is..................
  • Tensile
  • Compressive
  • Shear
  • Bending
Q.18
Belt drive is a flexible drive
  • True
  • False
Q.19
Flat belts are used for
  • Light Drives
  • Moderate Drives
  • Heavy Drives
  • None of these
Q.20
Which of the following is not a material used for belt
  • Balata
  • Cotton
  • Rubber
  • Powder
0 h : 0 m : 1 s