Q.1
It is customary for the first sheet of a working drawing set to include __________.
Q.2
Some common blocks used by architectural drafters include __________.
Q.3
The second line of dimensions out from the plan generally includes _________.
Q.4
Some of the standard Auto-CAD text styles used in architectural drawings includes _________.
Q.5
A fillet is a rounded surface on the ________ corner of a part.
Q.6
Two-point perspective is also known as:
Q.7
This type of projection is when projectors are parallel to each other, but are at an angle other than 90 degrees to the plane of projection:
Q.8
These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:
Q.9
Switches and relays should be shown in this position with no operating force or applied energy:
Q.10
The Press-Pull tool will ________ the face of a solid model in the direction it faces.
Q.11
These types of pipes are generally connected with bell and spigot joints or flanged joints:
Q.12
An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
Q.13
In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
Q.14
When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ________.
Q.15
This is formed where three or more surfaces intersect:
Q.16
The text used on a typical detail sheet should be ________.
Q.17
These items typically are not used in new designs, but are still common in high-power amplifiers:
Q.18
A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed drawings.
Q.19
Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
Q.20
This is used in applications for nonferrous construction:
Q.21
Auto-CAD refers to isometric ellipses as ________.
Q.22
Once the architect has finalized the house plans with the client any changes to the design requested by the client will require a ________.
Q.23
The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
Q.24
Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
Q.25
On a floor plan the dashed line that appears approximately 24" outside the exterior wall represents the ________.
Q.26
This type of surface is tipped to all principal planes of projection and does not appear true size in any standard view:
Q.27
This type of solid is formed by sweeping a shape along a linear path:
Q.28
In offset sections, offsets or bends in the cutting plane are all:
Q.29
In the mechanical design process the first step is to ________.
Q.30
This is a conical-shaped recess around a hole, often used to receive a tapered screw head:
0 h : 0 m : 1 s