Q.1

The efficiency of a boiler is defined as

  • ratio of heat actually used in producing steam to the heat liberated in the furnace
  • ratio of the mass of steam produced to the mass of total water supplied in a given time
  • ratio of the heat liberated in the furnace to the heat actually Used in producing steam
  • none of the above
Q.2

In surface condensers, the condensate and the cooling water mixes up.

  • True
  • False
Q.3

A device used to empty the boiler whenever required and to discharge the mud, scale or sediments which are accumulated at the bottom of the boiler, is called blow off cock.

  • Yes
  • No
Q.4

The ratio of the temperature rise of cooling water to the vacuum temperature minus inlet cooling water temperature is called

  • condenser efficiency
  • vacuum efficiency
  • nozzle efficiency
  • boiler efficiency
Q.5

A water level indicator is a device to indicate the exact water level in the boiler at any instant.

  • True
  • False
Q.6

Clearance ratio is the ratio of

  • clearance volume to the swept volume
  • clearance volume to the volume at cut-off
  • volume at cut-off to the swept volume
  • swept volume to the clearance volume
Q.7

A valve installed between the boiler and the feed pump is

  • blow off cock
  • feed check valve
  • steam stop valve
  • none of these
Q.8

Which of the following statement is correct ?

  • A horizontal steam engine requires less floor area than a vertical steam engine.
  • The steam pressure in the cylinder is not allowed to fall below the atmospheric pressure.
  • The compound steam engines are generally non-condensing steam engines.
  • all of the above
Q.9

Which of the following is correct ? (where pa = Actual mean effective pressure, pm = Theoretical mean effective pressure, and K = Diagram factor)

  • pa = pm/K
  • pa = pm x K
  • pa = K/pm
  • pa = pm + K
Q.10

A vessel into which the steam is exhausted and condensed after doing work in an engine cylinder or turbine is known as

  • steam condenser
  • steam boiler
  • steam preheater
  • economiser
Q.11

Which of the following compound steam engine requires a smaller flywheel ?

  • Receiver type
  • Tandem type
  • Woolf type
  • all of these
Q.12

The working pressure range for a La-Mont boiler is

  • 0.5 to 10 MN/m2
  • 1 to 15 MN/m2
  • 2.5 to 15 MN/m2
  • 3.5 to 20 MN/m2
Q.13

The ratio of the energy required to produce the artificial draught (expressed in metres head or J/kg of flue gas) to the mechanical equivalent of extra heat carried away per kg of flue gases due to natural draught, is known as

  • efficiency of the boiler
  • efficiency of the chimney
  • efficiency of the fan
  • power of the boiler
Q.14

The value of diagram factor depends upon

  • initial conditions of steam
  • back pressure
  • initial pressure of steam
  • all of these
Q.15

In a boiler, the heat is lost

  • to dry flue gases
  • in moisture present in the fuel
  • to steam formed by combustion of hydrogen per kg of fuel
  • all of the above
Q.16

In order to compare the capacity of boilers, the feed water temperature and working pressure are taken as

  • 50° C and normal atmospheric pressure
  • 50° C and 1.1 bar pressure
  • 100° C and normal atmospheric pressure
  • 100° C and 1.1 bar pressure
Q.17

In a boiler, the heat is lost

  • to dry flue gases
  • in moisture present in the fuel
  • to steam formed by combustion of hydrogen per kg of fuel
  • all of the above
Q.18

The draught in locomotive boilers is produced by a

  • chimney
  • centrifugal fan
  • steam jet
  • none of these
Q.19

The function of a piston in a steam engine is

  • to guide motion of the piston rod and to prevent it from bending
  • to transfer motion from the piston to the cross-head
  • to convert heat energy of the steam into mechanical work id) to exhaust steam from the cylinder at proper moment
Q.20

The function of an eccentric rod is

  • to provide reciprocating motion to the slide valve
  • to convert reciprocating motion of the piston into rotary motion of the crank
  • to convert rotary motion of the crankshaft into to and fro motion of the valve rod
  • to provide simple harmonic motion to the D-slide valve
Q.21

The crown of the fire box is made hemispherical in order to resist intense heat in the fire box.

  • True
  • False
Q.22

A condenser maintains a low pressure (below atmospheric) so as to obtain the maximum possible energy from steam and thus to secure a high efficiency.

  • Agree
  • Disagree
Q.23

The ratio of heat actually used in producing the steam to the heat liberated in the furnace is known as equivalent evaporation from and atC.

  • Correct
  • Incorrect
Q.24

The high steam and low water safety valve is not used in

  • Cochran boiler
  • Cornish boiler
  • Lancashire boiler
  • Locomotive boiler
Q.25

A receiver type compound engine, requires a lighter flywheel.

  • Yes
  • No
Q.26

For maximum discharge through a chimney, the condition is that height of hot gas column producing the draught should be

  • one-half the height of chimney
  • equal to the height of chimney
  • two times the height of chimney
  • four times the height of chimney
Q.27

The amount of water evaporated from and atC into dry and saturated steam is called evaporative capacity of a boiler.

  • Yes
  • No
Q.28

There is abouttoof coal saving when an economiser is used in a boiler.

  • True
  • False
Q.29

In a Woolf type compound engine, the high pressure and low pressure cylinders

  • have common piston rod
  • are set at 90°
  • have separate piston rod
  • are set in V - arrangement
Q.30

The difference between the atmospheric pressure and the absolute pressure is known as vacuum in a condenser.

  • Agree
  • Disagree
0 h : 0 m : 1 s