Which one of the following can completely balance several masses revolving in different planes on a shaft?
For two governors A and B, the lift of sleeve of governor A is more than that of governor B, for a given fractional change in speed. It indicates that
In vibration isolation system, if ω/ωn < 2, then for all values of damping factor, the trans-missibility will be (where ω = Angular speed of the system, ωn = Natural frequency of vibration of the system)
The minimum force required to slide a body of weight W on a rough horizontal plane is
A spring controlled governor is found unstable. It can be made stable by
The unbalanced force due to revolving masses
A combination of kinematic pairs, joined in such a way that the relative motion between the links is completely constrained, is called a
In order to facilitate starting of locomotive in any position, the cranks of a locomotive with two cylinders, are placed at
Critical damping is a function of
In a steam engine, the earlier cut-off with a simple slide valve may be obtained by increasing the angle of advance of the eccentric but reducing the throw of the eccentric and keeping the steam lap and exhaust lap constant. This method will cause withdrawing or throttling of steam.
Frequency of vibrations is usually expressed in
The rotor of a ship rotates in clockwise direction when viewed from stern and the ship takes a left turn. The effect of gyroscopic couple acting on it will be
The angle of the inclined plane at which the body just begins to slide down the plane, is called helix angle.
The component of the acceleration, parallel to the velocity of the particle, at the given instant is called
When a point at the end of a link moves with constant angular velocity, its acceleration will have
In order to have a good grip on the pulley, the V-belt should touch the bottom of the groove in the pulley.
A link or element need not to be a rigid body, but it must be a resistant body.
The coriolis component of acceleration leads the sliding velocity by
A governor is said to be stable, if the
The relation between number of pairs (p) forming a kinematic chain and the number of links (l) is
In forced vibrations, the magnitude of damping force at resonance is equal to the impressed force.
In a multiple V-belt drive, if one of the belt is broken, then we should replace
The time taken by a particle for one complete oscillationis known as periodic time.
In order to double the period of a simple pendulum, the length of the string should be
A Porter governor can not be isochronous.
In a Proell governor, the balls are attached to the extension of lower links.
The maximum and minimum value of the tractive force is given by
The module is the reciprocal of diametral pitch.
A body will begin to move down an inclined plane, if the angle of inclination of the plane is __________ the angle of friction.
Which of the following statement is correct ?
The inversion of a mechanism is
In a turning moment diagram, the variations of energy above and below the mean resisting torque line is called
If the controlling force line for a spring controlled governor when produced intersects the Y-axis at the origin, then the governor is said to be
When the speed of the engine fluctuates continuously above and below the mean speed, the governor is said to be
The coefficient of fluctuation of energy is the ratio of maximum energy to the minimum energy.
In a shaper mechanism, the coriolis component of acceleration does not exist.
A reed type tachometer use the principle of
Which of the following is a higher pair?
The primary unbalanced force is maximum __________ in one revolution of the crank.
The displacement of a flat-faced follower when it has contact with the flank of a circular arc cam, is given by (where R = Radius of flank, r1 = Minimum radius of the cam, and θ = Angle turned through by the cam)
When the sleeve of a Porter governor moves downwards, the governor speed
In a spring controlled governor, when the controlling force __________ as the radius of rotation increases, it is said to be a stable governor.
The height of a Watt's governor is
When two pulleys of different diameters are connected by means of an open belt, the angle of contact at the __________ pulley must be taken into consideration.
Please disable the adBlock and continue. Thank you.