In back-hand welding, the angle between the welding rod and the work is __________ as compared to fore-hand welding.

Forming is the operation of removing metal to the desired shape from the edge of a plate.

The length of hacksaw blade is the distance between the outside edges of the holes which fits over the pins.

Seam welding is best adopted for metal thickness ranging from

A progressive limit gauge has

The oxygen cylinder is usually painted with

Which of the following welding method uses a pool of molten metal?

Lap joints are employed on plates having thickness

In a unilateral system of tolerance, the tolerance is allowed on

A file with-teeth inmm is called bastard file.

A large electrode is used in un-shielded arc welding.

A basic shaft is one whose

A two high rolling mill consists of two rolls which rotate

A file withteeth inmm is called

Carburising flame is used to weld

The flux commonly used in brazing is

The electrode tip diameter (d) in spot welding should be equal to (where t = Thickness of plate to be welded)

The increase in hardness due to cold working, is called

For obtaining a cup of diametermm and heightmm by drawing, the size of the round blank should be approximately

When a pattern is made in three parts, the top part, is known as a

In arc welding, the electric arc is produced between the work and the electrode by

In a hot chamber die casting machine

Metal patterns are used for

The purpose of a riser is to

In welding copper alloys with TIG arc welding

Galvanising is a

In a centrifugal casting method

The electrodes used in spot welding have a tip of

The instrument which has all the features of try-square, bevel protractor, rule and scriber, is

The blank diameter used in thread rolling will be

The algebraic difference between the minimum limit and the basic size is called

The ferrous metals require more machining allowance than non-ferrous metals.

The draft or taper allowance on casting is generally

Blanking and piercing operations can be performed simultaneously in a

When a hole or cavity to be cored is not in line with the parting surface, then a __________ is used.

The cross-section of a chisel is usually

The temperature of oxy-hydrogen flame is __________ oxy-acetylene flame.

In a four high rolling mill, there are four rolls out of which

Which of the following welding process uses non-consumable electrodes?

In a bilateral system of tolerance, the tolerance is allowed on

A pattern maker's shrinkage rule considers

The bloom is smaller than a billet.

In average work, the tolerance produced by investment casting method is

A plug gauge is used to check the diameter of shafts and studs.

Which of the following methods can be used for manufacturing 2 metre long seamless metallic tubes?

When a pattern is made in three parts, the bottom part is known as a cope.

The tolerance produced by shell moulding process of casting is

In back-hand welding, the angle between the welding torch and the work is kept as

A saw which cuts wood during the return stroke of the saw is known as

In __________ welding, the weld may be made either from left to right or from right to left.