MCQGeeks
0 : 0 : 1
CBSE
JEE
NTSE
NEET
English
UK Quiz
Quiz
Driving Test
Practice
Games
Practice
4.3.4 Practice Questions Quiz
«
Multiple Choice Questions
»
1
2
3
4
5
6
7
8
You have two switches that you need to connect using their uplink ports. The switches do not support auto-MDI. which type of cable should you use?
0%
Straight-through
0%
Crossover
0%
RS-232
0%
Rollover
Use the exhibit to match the connector type on the corresponding letter on the right.
0%
An unmanaged switch and CAT5e cabling
0%
A=DB-25B=DB-9C=RJ45D=RJ11E=LCF=BNCG=F-Type
0%
Connect pin 1 to pin 8, pin 2 to pin 7, pin 3 to pin 6, and pin 4 to pin 5
0%
RS-232
Which of the following standards is typically used in a rollover cable?
0%
Serial
0%
Rollover
0%
RS-232
0%
Crossover
You want the LAN port on a router to the uplink port on a switch. The switch does not support auto-MDI. Which type of cable should you use?
0%
Crossover
0%
Straight-through
0%
Rollover
0%
Connect pin 1 to pin 8, pin 2 to pin 7, pin 3 to pin 6, and pin 4 to pin 5
You need to connect a workstation to a switch using a regular port on the switch (not an uplink port). The switch does not support auto-MDI. Which type of cable should you use?
0%
Crossover
0%
Connect pin 1 to pin 8, pin 2 to pin 7, pin 3 to pin 6, and pin 4 to pin 5
0%
Straight-through
0%
Rollover
Which of the following connectors is typically used on one end of the rollover cable?
0%
RS-232
0%
Crossover
0%
Straight-through
0%
Serial
You manage the two-location network shown in the exhibit. Workstations and servers at each location connect to a patch panel using behind-the-wall wiring. The patch panel then connects network hosts to one of three 1000BASE-T switches. Routers are implemented at each location together using a private WAN. The switch ports have auto-MDIX disabled.
0%
An unmanaged switch and CAT5e cabling
0%
A=Cat 6 straight-through UTPB=Cat 6 straight-through UTPC=Cat 6 crossover UTPD=Single-mode fiber optic
0%
Crossover
0%
Connect pin 1 to pin 8, pin 2 to pin 7, pin 3 to pin 6, and pin 4 to pin 5
You have purchased a new router that you need to configure. You need to connect a workstation to the router's console port to complete the configuration tasks. Which type of cable would you most likely use?
0%
Connect pin 1 to pin 8, pin 2 to pin 7, pin 3 to pin 6, and pin 4 to pin 5
0%
Rollover
0%
Crossover
0%
Straight-through
0 h : 0 m : 1 s
«
Multiple Choice Questions
»
1
2
3
4
5
6
7
8
0
Answered
0
Not Answered
0
Not Visited
Correct : 0
Incorrect : 0
Report Question
×
What's an issue?
Question is wrong
Answer is wrong
Other Reason
Want to elaborate a bit more? (optional)
Support mcqgeeks.com by disabling your adblocker.
×
Please disable the adBlock and continue.
Thank you.
Reload page