A set of two mutually perpendicular datum planes is required for coordinate dimensioning.
Avoid dimensioning to hidden lines.
When a finished part is measured, it may vary slightly from the exact dimension specified.
Although an engineer has placed dimensions in specific locations the drafter has the freedom to arrange them as he deems necessary.
The drafter should always try to dimension to the profile view of an object when possible.
Tolerance issues are primarily a concern in manufacturing rather than in the design and drafting process.
Dimensions are given in the form of distances, angles, and notes only when using metric units.
Typically, all dimension values and notes are lettered horizontally and should read from the bottom of the sheet.
Placement of dimensions on a drawing is controlled by ________.
This is a line terminated by arrowheads, indicating the direction and extent of a dimension:
One way to evenly space dimensions on a drawing is to use the ________.
The condition of a part when it contains the least amount of material is referred to as ________.
Baseline dimensions are referenced from a common geometric feature known as a ________.
Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:
The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.
This is used to indicate that a surface is to be machined:
This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:
A circular arc is dimensioned in the view where you see its true shape by giving the value for its:
The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
Please disable the adBlock and continue. Thank you.